As a manufacturer and trader of welding tables, Xin Tian Environmental Equipment Co., Ltd, we provide reliable and guaranteed quality welding tables at reasonable and fair prices, so that you can do a great job with little money.
Below is a list of factors you need to consider when choosing a welding table.
Selecting a welding table with quality workmanship can be done in the following ways:
1. Welding quality:
- Welded seam appearance: quality welded table welds should be uniform and flat, showing continuous lines, without defects such as broken points, leakage of welds, pores, slag and other defects. Welds are moderate and consistent in width; excessively wide or narrow welds may indicate poor welding workmanship.
- Welding strength: you can check whether the welded parts are firm and free from looseness, shaking or noise by gently shaking the table or applying some pressure on the tabletop. If the welding strength is not enough, the table is prone to problems such as weld cracking during use, affecting the service life.
2. Material selection:
- Steel quality: the commonly used steel for welding tables are Q355 carbon steel. High-quality carbon steel should have good strength and toughness, the surface without obvious scratches, pits, rust and other defects.
- Auxiliary materials: The quality of welding auxiliary materials such as welding rods and wires will also affect the quality of the welding table. Welding materials that match the steel should be selected to ensure the firmness and reliability of welding.
3. Structural design:
- Overall structural stability: the overall structure of the table should be stable, and the four legs or support structures should be evenly distributed and firmly connected to the tabletop. The table can be placed on a flat surface to check if it is smooth and not tilted or wobbly. For some large or heavy welding tables, attention should also be paid to whether there are reinforcement or support structures at the bottom to improve the load-bearing capacity and stability of the table.
- Details of the design reasonableness: pay attention to the table corners to deal with whether the rounded corners, to avoid sharp corners cause safety hazards. Also, check whether the tabletop has a reasonable drainage design (if applicable) to prevent liquid from pooling on the tabletop.
4. surface finish:
- Coating quality: If the table surface has been painted or other coating treatment, check whether the coating is even and smooth, without running marks, blistering, flaking and other phenomena. Good painting can protect the table from corrosion and also improve the aesthetics of the table.
- Rustproof treatment: For welding tables used outdoors or in humid environments, rustproof treatment is especially important. You can check whether the table's welding parts, cutting edges and other rust-prone parts have been effectively rust-proofed.